ETC Source Four LED Series Manuel d'utilisateur télécharger pdf (Page 28)

23 Source Four LED Profile v1.4.0 User Manual

Adjusting the Yoke Position

The Source Four provides multi-positioning capabilities within its yoke for overall fixture height and

angle.

Setting the Fixture Height Within the Yoke

The Source Four has a two-position yoke for modifying the overall height in which the fixture is

mounted. To change the height position, perform the following steps.

Figure-1.10 Adjusting the yoke position.

Step 1: Remove the yoke locking knobs, washers, and hex bolts from either side of the

fixture.

Step 2: Raise or lower the fixture to the desired position within the yoke.

Step 3: Reinstall the yoke’s hex bolts, washers, and locking knobs.

Step 4: Tighten the yoke knobs to secure in position.

Low clearance position

General use position

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 95 96

Pas de commentaire

ETC Source Four LED Series Manuel d'utilisateur Page 28