Etc LED Configuration Software Programming Guide Manuel d'utilisateur télécharger pdf (Page 8)

5 LED Configuration Software 1.0 Programming Guide

LED Config Tool Interface

The LED Config Tool interface window consists of panes and tabs. Each displays

information or allows you to configure the connected fixtures.

Figure-1.2 LED Config interface Quick Setups tab window.

Note:

Not all functionality of LED Config Tool may be available for the fixture you are

configuring. Refer to the fixture’s user manual for information about its functionality.

Before you launch the LED Config Tool software, connect Gadget or a gateway to the

computer. LED Config will then recognize the connected devices.

Refer to Gadget USB to DMX/RDM Interface Setup Guide or the gateway’s user manual

for using these devices.

Discovered Devices pane

Status bar

Properties tabs

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

Etc LED Configuration Software Programming Guide Manuel d'utilisateur Page 8