Etc Sensor+ Touring Rack CEM+ to CEM3 Retrofit Manuel d'utilisateur

Sensor+ Touring Rack (SP+ Series) CEM+ to CEM3 Retrofit ManualRevision ACopyright © Electronic Theatre Controls, Inc.All Rights reserved.Product infor

8 CEM3 Sensor+ Touring Rack Retrofit ManualBackplane SettingsUpgrade kit backplanes ship from the factory with all DIP switches in the off (down) posi

2 The Retrofit 9Step 3: Connect the new power adapter harness to the backplane power header. Note the pin shapes for proper orientation. It will only

10 CEM3 Sensor+ Touring Rack Retrofit ManualStep 9: Plug the control input ribbon cable into the blue header on the backplane. The connector is keyed

2 The Retrofit 11Replace AF Cards (AF Racks Only)If your touring rack supports Advanced Features (AF) you will need to replace the AF cards as well.AF

12 CEM3 Sensor+ Touring Rack Retrofit ManualStep 3: Place the lock assembly in the new door and secure it with the retention nut using a 7/8” open end

2 The Retrofit 13Verify the RetrofitStep 1: Put the dimmer modules back in the rack in the correct/original order.Step 2: Put the CEM3 in the rack mak

14 CEM3 Sensor+ Touring Rack Retrofit Manual

ETC permits the reproduction of materials in this manual only for non-commercial purposes. All other rights are reserved by ETC.ETC®, and Sensor® are

Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736London,

Introduction 1IntroductionThis manual is intended to guide ETC Service Technicians through the process of upgrading existing Sensor®+ Touring Racks to

2 CEM3 Sensor+ Touring Rack Retrofit ManualSafetyPlease note the following safety warnings before use:• Disconnect power from the racks before all mai

1 Unpack and Organize 3Section 1Unpack and OrganizeThe table below lists the parts and components needed to retrofit a Sensor+ touring rack (SP+ 48, 9

4 CEM3 Sensor+ Touring Rack Retrofit Manual

2 The Retrofit 5Section 2The RetrofitRack GeographyThroughout this manual directions are given which refer to the front, back, left, and right sides o

6 CEM3 Sensor+ Touring Rack Retrofit ManualRemove the OldStep 1: Accessing the rear of the backplane through the rack side panel, disconnect the multi

2 The Retrofit 7Step 6: Unscrew and remove the plastic collars from around the termination buttons on the new control panel circuit board.Step 7: Slid