Etc Source Four Fresnel Manuel d'utilisateur télécharger pdf (Page 7)

Lamp Information 3

Installing and Replacing the Lamp

A lamp must be installed before you use the fixture.

Figure-2 Lamp door on bottom of the fixture.

Step 1: Disconnect power to the fixture before installing or replacing the lamp.

Step 2: On the bottom of the fixture, turn the latch on the lamp door one-quarter turn and then

open the door.

Step 3: Remove the lamp holder assembly by turning the knurled knob counterclockwise to

release the lamp socket assembly.

Note:

Verify that the HPL lamp you intend to install is suitable for your facility’s voltage;

115-, 120-, 230-, and 240-volt HPL lamps are available.

See HPL Lamp Table, page 2. Operating HPL lamps above their rated voltage

reduces lamp life and can cause premature lamp failure.

WARNING:

Unplug the fixture and allow it to cool down before attempting to change the

lamp.

Lamp door latch

Lamp door

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Pas de commentaire

Etc Source Four Fresnel Manuel d'utilisateur Page 7