Etc Sensor3 CE (ESR3) Rack Manuel d'utilisateur télécharger pdf (Page 18)

10 Sensor3 CE Rack (ESR3) Installation Manual

Securing Multiple Racks (Optional)

Multiple racks can be connected to each other for greater stability.

Step 1: Use M8 spin lock bolts and lock nuts in the front and at the back to bolt the racks

together at the bottom.

Step 2: (ESR3-36 and ESR3-48 only) Remove six screws from the tops of adjacent

racks, as shown below.

Step 3: (ESR3-36 and ESR3-48 only) Place a rack splice plate over the empty screw

holes and replace the screws you removed in Step 2 as shown above.

Repeat Steps 1, 2 and 3 until you have secured all the racks.

Note:

If you want to install the control cable through the side of the racks, you should

remove the side cable knockouts before connecting the rack.

Note:

The front bolt is difficult to reach – you may need a magnetic bolt-driver or socket

extension.

Hole for bolting

racks together

(recessed)

Hole for bolting

racks together

Figure 6: Placement of rack connecting holes

Temporarily remove

six screws from this

area

Install the rack splice and

replace the screws to

secure it

Figure 7: Screws to remove to connect two racks

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Pas de commentaire

Etc Sensor3 CE (ESR3) Rack Manuel d'utilisateur Page 18