Etc SmartFade ML v3.0.1 Manuel d'utilisateur télécharger pdf (Page 81)

4 Edit 73

Run Modes

There are three run modes for a Sequence: Manual, One Shot and Loop (default).

Step 1: Press EDIT

Step 2: Press TIME.

Step 3: Now press a bump button for a sequence. You will get this display.

Step 4: Use encoder wheel 3 to select [Run mode]. Press (MENU) to confirm.

Step 5: Select run mode using encoder wheel 3. Press (MENU) to confirm.

Step 6: Done. Press EDIT to exit.

Menu choice Console Feedback

Loop Wheel 3 Default behavior for Sequences (not avail-

able for the Stack). The Sequence will loop

from the last step back to the first, endlessly.

Manual Wheel 3 Default behavior for the Stack. A press of the

GO key is required to advance to the next

step. Sequences in this mode use the bump

button to advance to the next step.

One Sht Wheel 3 Runs sequences through one full cycle only.

Stack will run automatically through the cue

list once with a single press of GO.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 103 104

Pas de commentaire

Etc SmartFade ML v3.0.1 Manuel d'utilisateur Page 81