ETC Source Four LED Series Manuel d'utilisateur télécharger pdf (Page 68)

63 Source Four LED Profile v1.4.0 User Manual

Finishing the Sequence

After each of the steps have been configured, set the End State. End state is what the

fixture does once it completes the Sequence. Two end state options are available and both

options repeat indefinitely until the Sequence is deactivated. To access the end state

options, you must first program an additional and final step within the sequence using

Preset 0. Preset 0 marks the end of the Sequence and opens the End State menu line.

Preset 0 may only be used once within a Sequence. If you want the Sequence to repeat

automatically, you may only define up to 23 steps with Presets 1 through 24, since the final

step must be reserved for Preset 0.

Loop

Once the fixture completes the entire sequence, it immediately returns to the beginning and

starts the sequence over again, in order.

Bounce

Once the fixture completes the entire sequence, it reverses the order of the presets and

steps backward through them until reaching the starting step, at which point it starts the

Sequence over again, in the original order.

Figure-3.27 Setting Sequences End State.

Step 1: On the Sequences menu, scroll to Preset and press [Enter].

Step 2: With the Preset number selected Press [Up] or [Down] until you reach 0.

Step 3: Press [Enter].

Link Time on the screen is replaced with End State.

Step 4: Scroll to End State and press [Enter] to toggle between the options.

Step 5: If the Sequence is not active, scroll up to Action and press [Enter].

Sequences

Sequence: * 3

Status: Active

Rate: 100%

Step: 01

Preset: 0

End State: Loop

Copy to Other Fixture

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 95 96

Pas de commentaire

ETC Source Four LED Series Manuel d'utilisateur Page 68