ETC Source Four LED Series Manuel d'utilisateur télécharger pdf (Page 79)

3 Operation 74

Studio DMX Control

When controlled via DMX, the first three channels adjust the output in the following order.

Channel 5 controls strobe.

When adjusting white point via DMX, the full gamut of 2700 to 6500K is available, but

common settings of 3200K and 5600K are quickly accessible at the lowest and highest

DMX values, respectively. The range of control on channel 2 is distributed as follows.

When adjusting tint via DMX, the range of control on channel 3 is distributed as follows.

Additional channels for other functions, such as strobe and Plus 7, can also be activated, if

desired, starting with channel 4.

Channel Output

1 Intensity (Brightness)

2 White Point

3Tint

5 Strobe

DMX Value White Point

000 3200K

001 to 254 Continuous adjustment from 2700 to 6500K

255 5600K

DMX Value Tint

000 Neutral white (at the specified white point)

001 Extreme green (approximately 2x plus green)

002 to 127 Moving from green toward neutral white

128 Neutral white

129 to 254 Moving from neutral white toward magenta

255 Extreme magenta (approximately 2x minus green)

Note:

When using DMX to control the fixture in Studio mode, the default data-loss behavior

is different than in other operational modes. If the DMX signal is lost, the fixture

automatically holds the last look forever (HLL-4ever) and this look persists through

infinite off/on power cycles, until the DMX signal is restored or the fixture settings are

adjusted manually via the User Interface.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 95 96

Pas de commentaire

ETC Source Four LED Series Manuel d'utilisateur Page 79